Armature Winder Rotor Winding Machine Two Flier Slotted Commutator PMDC Motor

Quick Detail

Package & Delivery Lead Time

Detailed Description

Two Flier Slotted Commutator PMDC Motor Armature Winder Rotor Winding Machine Application: Armature winder for slotted type commutator armature,Vacuum cleaners hammers power tool Advantages: 1. Slot type armature with thin, thick wire machine can bed handled by automatic winding machine, Machine had good feedback of winding a small0.25mm wire diameter armature 2. Have good adaption for slot type commutator with groove, No need to work with special designated slotting undercutting machine 3. Got good feedback in wide application from customers 4. 98% yield rate above assured when the slot commutator quality is good 5. Till now it is the best machine in China for winding slotted type armature Feature: - - - - Lap winding with double flyer wire gauge range | Usually 0.20~1.2mm, Max wire machine handled 1.35mm (about AWG16) | Armature commutator type | Slotted type riser type not hook type | Automatic or semi automatic | You only need to load and unload armature, other actions such as hooking, winding, indexing and cutting are wound by machine automatcially | - - - - Winding and welding are the two most improtant process in building motors, WIND-ST-TD2B winding machine is mainly for automatical lap winding a slotted type commutator armature as below Wound slotted commutator Straight stack armature and Skew lamiantion rotor by armature winder Question and Answer: Q:Wire size and Wire slot size relation (Length,width and depth), A: The wire slot should have enough space for the wire to stay inside Wire size 17AWG (1.15 mm), Slot: blade width 1.143, length=7.14 mm, depth= 5.95 mm and we think if the depth is bigger, the wire can acquire more space to stay inside slot, while depth is more, length is more too, Q: How to settle if there isindexing issue. A: Could you please check if the commutator was pressed consistanctly each time at same location according armature stack? The push pin witness marks on the commutator are consistent. Because armature commutator and stack position is very important for indexing consistantly How to do pin hole test for the wound armature to verify the wound armature quality? Operation steps forbrine pinhole test for enamelled wire 1.Prepare copper wire or wound armature samples according to the requirements 2. Connect the power supply, switch on the power, adjusting DC voltage meter adjustment knob, the voltage value is 12V. 3. Copper wire or wound sample was immersed in 0.2% of the concentration of salt solution (main ingredients are water, salt, pure alcohol, phenolphthalein, 3%) In the sample, the negative electrode connected with DC power supply, DC power connected with the positive solution. 4.Within a minute, observe the change of the sample, if the sample has no obvious change, indicating that the sample without pinhole, if the red and the penetrating phenomenon around the sample you need to pay attention to, at this time, explain the pinhole, carefully count, there is the phenomenon of a few, there are a few pinholes. 5.After the experiment, turn off the power and take out the sample Please click below picture to view video Photo Contact:Shanghai Wind Automation Equipment Co.,Ltd Email: emily@motor-machinery.com Skype: motor.machinery Mobile: +86-17721374887 Website: [http://][www.statorwindingmachine.com]; http://[www.coilswinding.com]

Basic Company Information

Shanghai Wind Automation Equipment Co.,Ltd

Company Advantage

Detail Company Introduction