Repair and maintenance of electric operating table Our hospital has a laminar flow operating room 18. Each room is equipped with electric operating table l sheets. A spare bed, Electric Operating Table 6.
Lack of abundance bed 6. Domestic bed 7, are based on electro-hydraulic-powered, the handle button control, widely used in orthopedics, general surgery,
brain outside, obstetrics and gynecology, urology, microsurgery, ENT, ophthalmology and other sections of the multi-functional integrated surgery Taiwan.
These electric operating table works basically the same. Simple operation. Flexible and reliable, it is basically the same in terms of care and maintenance.
Because our hospital is the only one in the city three general hospitals, the average operation more every day. Electric operating table use more frequently,
so do electric operating table maintenance is very important for the normal development of clinical work. www.medicalprecise.com 1, the working principle Electric operating table adopts electro-hydraulic system that controls the body's structure by the control switch, speed control valve, solenoid valve.
Provide hydraulic power source via the electro-hydraulic gear pump. Reciprocating motion of each bi-directional control hydraulic cylinder. And button
control operating table is transformed by a variety of locations, with a bed as a whole rise and fall, tilt left and right, front and rear tilt, rise back
drop, electric bed pan and electric brake function. So as to meet the requirements of the surgical procedure River. Electric operating table is
electronically controlled hydraulic bed. T as its principle is AC 220 V voltage through step-down transformer becomes 22 V AC voltage. By forming a 24 V DC
voltage rectifier. And outputs it to the control panel, and then the corresponding key on the front panel control related to the solenoid valve and pump,
complete the relevant action. The bed total of nine solenoid valve and a solenoid valve. According to their different combinations, respectively, to control
the operation of the bed 10. 2, the main structure Electric operating table tops by section, subject, electrical control and accessories and other components. Operating table tops South Head board, backplane,
seat and leg panels, including the head board, backplane surface, seat board, the board left leg, right leg, face plate surface and the backs of 6 parts.
Operation control device for an electric operating table of commonly used electro-hydraulic transmission. Mainly by electric gear pumps,operating table
hydraulic bucket, relief valve, solenoid valve, position control switch and power supply and other components. Electro-hydraulic transmission control via a
wired hands on the controller, infrared remote control, foot controller and secondary controller is complete. Common operating table accessory generally
equipped with dirt bucket, corbel plate, prop leg plate, head frame, arm plates, rods and anesthesia infusion racks. Postural adjustments and to help meet
the need for surgery [21. 3, the basic breakdown maintenance check points (1) Check the power indicator light. If the indicator light. Said power supplying. Under normal circumstances, to check the following: ?? By operating table
up, down, upper back, lower back, turn around horizontal and vertical turn up and down, the solenoid valve and the motor. Should have action. ?? Press the
audience, only to release the brake solenoid valve action.