LYT-013 Organic silicone gel

Quick Detail

Package & Delivery Lead Time

Detailed Description

Characteristic and Usage: LYT- 013 is double component, it cures to be high performance gel after crosslinking through the Si-H addition reaction; The elastomer has excellent electric property, good resistance of high low temperature(-40 ~150°C), excellent deep hardening performance and certain adhesiveness. It’s anti-aging, moisture-proofing, waterproofing, and has no corrosion to the bonded material and no pollution to surroundings. It accords with RoHS instructions and related environmental requirement. Apply to solar energy, sensors and cars, high power rectifier module and the electronic components of photoelectric device, integrated circuit and the junction box for the sealing and waterproofing, moisture proofing protection. Typical properties: Test Item Technical parameters Before curing(A component) Appearance Clear liquid Viscosity(mPa.s) 1000--4000 Before curing (B component) Appearance Clear liquid Viscosity(mPa.s) 2500--4000 Mix ratio(A:B) 1:1(volume ratio or weight ratio) After curing Appearance Clear liquid gel Curing time in room tempreture(hour) <24 80℃ curing time(min) 30 Penetration (1/00mm) 200-300 Remark：The above data is tested in room temperature 3 Application: 4 Usage: a) Measuring: Weigh A component and B component precisely. b) Mixing: Put component B into container which has component A, then mix adequately. c) Deaerating: put the mixed liquid into the vacuum cabinet to deaerate. d) Pouring: Encapsulate the defoamed adhesive into the products to finish the pouring operation. (Before potting, the surface of parts and the mixing container keep clean and dry, can't contact chemical compounds like N, P, S, Sn, Pb, Hg, As, etc., so as not to affect curing.) e) Vulcanizing: After pouring, put the product in room temperature and let it cure naturally. Or you can choose heat curing method. Package, Storage, Transportation and Attention: 1,2kg/ set (component A 1kg and component B 1kg). This product can be shipped as regular chemical products for its harmlessness. Dry place for 12 months ( room temperature). Some materials, chemical, curing agent, plasticizer can control the gel material’s curing. There are are including: 1 organotin and other metallorganic compound 2 sulphur, polysulfide, polysulfone and other sulfur-containing 3 amine, polyester rubber and other ammoniac 4 phosphorig and other phosphorig-containing 5 acid materials (organic acid) 6 Some flux residues If any doubt that whether some kind of material would restrain the curing, we suggest a experiment test for the suitability before mass production.

Basic Company Information

ShenZhen LiYiTe Technology Co.,Ltd

Company Advantage

Detail Company Introduction