Quick Detail
Place of Origin
HS-CODE
S05-
Package & Delivery Lead Time
Detailed Description
Introduction
Brand: Taid
Name: LED 5050 light bar
Operating voltage: 12V (recommended LED light bar dedicated power supply, such as the use of other fragile light of poor power supply)
Light Description: White, Cool White, RGB (default is white)
Beam angle: 45 degrees angle
Dimensions: 30LEDS/M, 60LEDS/M, 72LEDS/M
Material: 5050 SMD U&V-groove aluminum plate
Installation: Fixed Installation
Chip selection:
1.Epistar Chip
2.life span50,000 hours.
3.light color is more stable, long service life.
4 more environmentally friendly.
Power use:
1.All capacitors are used for more than 105℃long-life capacitors, other components are high quality.
2.100% full load burn-in test.
3 ambient temperatures of up to 70.
4 short-circuit protection, overload protection, overvoltage protection.
5 circuit design, but on the most stable and secure solution.
Process:
1.lamp beads seamless contact with the substrate, thermal conductivity can be described as the perfect chip, greatly increasing the life expectancy and reduce the lumen.
2.the selection of welding temperature soldering iron, solder temperature is 260℃,LED pad with a soldering iron in contact no more than 3 seconds, reduced iron temperature and electrostatic damage to the chip.
3.Shanghao heat all applicable quality silicone gel, so that better heat dissipation.
4.All the wires are all put heat shrink tubing, so that the wire is more wear-resistant, heat, acid, alkali salt, an increase of service life.
Installation instructions Notes:
1.Install the required materials for the LED light bar, the DC power supply, wire (use thick copper wire) and glass glue.
2.DC wiring installation, L, N then AC, regardless of positive and negative, + V then positive,-V (COM) then negative, then positive and negative note this can not be reversed.
3.take into account the connection wires have power consumption, the proposed light of the DC power supply rated power does not exceed 80%, 72 bead counter light bar is 17.2 watts per meter. For example: 10meters 72 bead counter of the light power is 17.2 watts per meter X10 meters = 172 watts, the DC power required will need to choose at (172 divided by 0.8) = 215 watts or more.
4.DC Power Terminal: DC power supply wiring methods are mainly two kinds, one is in series, one is parallel. It is also proposed series does not exceed 3 meters, if more than 3 meters from the re-wiring the DC power supply terminal, otherwise it will not appear in front of bright light behind the case.
Install before:
1. Please test the power and light of each, determine not damaged during transport;
2.Power calculation to determine the number of meters connected to a power strip. Calculation method: the power of light per meter of length of light X ÷ 0.8, serial and parallel calculation methods, like;
3 to determine the alignment program to ensure the shortest connecting wires, wiring the most simple;
4.to start the installation, the aluminum stick to the counter inside the tank can be. Installation to be careful to avoid pulling off the lamp wires.
Common problems and solutions:
1.does not light, check the circuit is connected, is bad, whether light of the positive and negative reversed.
2.Light intensity is significantly lower rated power supply, check whether the power is less than the light bar, or connecting wire too small, causing excessive power consumption of connected wires.
3.LED rear light bar significantly higher than the previous series, please check the length is more than 3 meters.
Luminous color and is ideal for:
1.Warm white: gold, jade, colored gems
2.white: silver, white, amber, clothing, leather goods
3.cold white: diamonds, crystal, watches
Click enlarge Image
