Relay

Quick Detail

Package & Delivery Lead Time

Detailed Description

Ⅰ.Pin location and connection 1. J3 (J3 is Electrical machinery wiring mouth) has two wiring mouths : 1 is for positive electrode. 2 is for cathode 2. J5 (J5 place is the electromechanical power supply external power supply mouth, namely: When the electricity use's electrical machinery is the +12V direct current this mouth on the external connection +12V direct current original, when the electricity use's electrical machinery is the +24V direct current this mouth on external connection +24V, please notice that this connection meets the direct-current power supply voltage should better not to surpass the +50V direct-current power supply, will otherwise burn out the relay!!!)Place” 3” the wiring mouth meets the external connection electromechanical power supply's cathode,” 4” the wiring mouth meets the external connection electromechanical power supply's positive electrode. 3. 3rd, J4 (J4 place is circuit wafer work power source connection, circuit wafer work supply voltage limiting value +12VDC) place” 5” the wiring mouth receives a telegram the source cathode,” 6” the wiring mouth receives a telegram the source positive electrode. Ⅱ.Tech. Spec. 1. operating voltage: +12VCD 2. operating current: 30mA 3. Relay external connection load voltage: 0-50VDC 4.Relay external connection load current: 0-50A 5.operating current: 433.92MHz 6.modulation: ASK 7.receiver sensibility: -100-110dbm 8.storage temperature: -40℃ +85℃ Ⅲ.correct ID method 1. we make each KST－RF019 with unique ID to avoid interference. Then, you need correct ID to make it work. 2. 1. Electrify the RKX012 3. Press the leaning key, LED lighes, it means the beginning of correct ID 4. press any button twice, LED lights twice, it means success, then retreat 5. repeat twice or three times can correct other transmitters; (15 is maximum) 6. The only ID code is storaged in EEPROM during correct, so it will not lost after power off 7. If there is no new transmitter need to correct within 15S, it will retreat by itself Ⅳ.the way for KST-RKS012 to eliminate all of KST-RF019 ID 1.electrify KST-RKS012 2. continue to press Lean Key, LED will light 4 times after 6s,it means all of the code which had corrected is eliminated, then loosen it 3. repeat (一),1 ,2 ,3 ,4,if you want to return to correct ID Ⅴ. Working method 1. Presses down on the KST-RF019 remote control's upward key, on control panel's end relay K1 often beginning and the public end attracts gathers, often the dead end and the public end separate, the electrical machinery clockwise, presses on KST-RF019 again the stop key (middle key), on control panel's end relay K1 often dead end and the public end attract gather, often the beginning and the public end separate, the electrical machinery stops 2. Presses down on the KST-RF019 remote control's downward key, on control panel's end relay K2 often beginning and the public end attracts gathers, often the dead end and the public end separate, the electrical machinery reverse, presses on KST-RF019 again the stop key (middle key), on control panel's end relay K2 often dead end and the public end attract gather, often the beginning and the public end separate, the electrical machinery stops 3. If needs other output state to be possible in addition to jump the line establishment through control panel's on J6 position to obtain, the special details may with decide according to the customer demands.

Basic Company Information

Shenzhen KST Techonplogy Co., Ltd.

Company Advantage

Detail Company Introduction