Intelligent wireless roof detector

Quick Detail

Package & Delivery Lead Time

Detailed Description

Despriction: Adopting advanced digital signal processing technology, Compounding of high precision passive infrared detector and logical digital circuit design, feature intelligent power save, auto- tamperature compensation, low battery alarm and so on. It emits wireless digital signal to start the control panel for alarm through detecting human being body infrared heat. Nice looking, Reliable and fine quality.It can be compatible with many other control panel. FUNCTION 1. Tamper switch: it will send alarm signal if cover is disassembled 2. Preset coding with the control panel: Switch the protection zone to “ON”, press the tamper switch and send wireless signal, the control panel sounds, it means that coding is completed matched.(refer to the coding program of control panel operation instruction and relative detector) 3. Low battery alarm: when battery is low voltage, the human being body moving, LED flashes five times. In static environment,it is not activated. 4. Coding address: preset by manufacture or by user. 5.Protected time choosing: 3 seconds or 30 seconds, it is preset by playing pins. 6. Compatible with many control panel. (3)SPECIFICATION Power supply: 9VDC Li-ion & manganese battery 500mAh Working current: static < 30µA; alarm < 16 mA Wireless parameter: frequency 315MHz or 433MHz, Transmitting distance >150 m (wide area without interfere) Detecting range: high 2.4m from ground, covered diameter:7.3m, high 4.5m, covered diameter: 9mWorking condition: working tamperature: -10ºC~55ºC Product size: Φ96*25mm (4) INSTALLATION. 1, Installing guide Open the cover, connect the battery, than the detector starts to work. Press tamper switch to transmit the signal to match coding of the control panel Close the cover, when installing it, please learn the following diagram. When the power is on, the LED flashes for about two seconds, the detector will continues to delay for about three seconds or thirty seconds (it depends on protecting time choosing),than it enters the activate situation. If intruder enter protection area. The detector immediately sends out wireless alarm signal. 2. Usage Walk test: to set the protecting time choosing to 3 seconds by playing pin, simulated as intruder go into the protection area, the LED flashes for about 2 seconds, the detector sends out the wireless signal, meanwhile, the control panel should receive the signal. After walk test, it tested well, please set the protecting time choosing to 30 seconds so as to start to work. Note: When setting the protecting time, please shut off battery power and press tamper switch once. (5) CAUTION Install the detector to the proper place where intruder must enter. Do not face the detector to any area where window, lamp-house,heat thing and so on. It is used for indoor,not for outdoor. When installing, do not drop down or hit the detector so to avoid the internal infrared sensor.Do not touch the sensor lens so to avoid the detecting distance and sensitivity. Have termly walk test

Basic Company Information

Shenzhen Autosecu Technology Co., Ltd

Company Advantage

Detail Company Introduction