10/100/1000M fiber Media converter:FMC-1110

10/100/1000M fiber Media converter:FMC-1110cenny.xu[at]hotmail.com

DescriptionThe media converter transform the transmission media of Ethernet signal from CAT5 to optical fiber. it can extend the transmission distance to several kilometer or hundred kilometer.Using media converter is a economical solution to achieve long distance transmission base on current status.

OverviewThis product supports IEEE802.3 10 Base-T standard/IEEE 802.3u 100Base-TX/FX standard/IEEE 802.3z 1000Base-TX/FX standard,as well as full duplex and half duplex mode. 

Feature1. InterfaceRJ-45 interfaceThe transmission media adopts CAT5 twisted-pair with typical length of 100 meter. It features the function of automatically identifying the through line and cross wire Fiber interface SC/ST fiber interface is of duplex mode type, including two interfaces, namely TX and RX. When the two sets of optical transceiver are interfaced or connected to switch with fiber interface, the fiber is in cross connection, namely "TX-RX", "RX-TX" (direct butting for single optical fiber).2. ConnectionThe network device (work station, hub or switch) with RJ-45 interface is connected to RJ-45 jack of optical transceiver through twisted-pair. And the multi/single mode fiber is connected to SC/ST fiber interface of the optical transceiver. Then switch on. The corresponding LED is on for correct connection. (See the table below for the LED indicator lamp)

Specifications1. Standard Protocol: IEEE802.3 10 Base-T standardIEEE 802.3u 100Base-TX/FX standardIEEE 802.3z 1000Base-TX/FX standard2.Connector:oneUTPRJ-45connector,oneSC/STconnector3. Operation mode: full duplex mode or half duplex mode4. Power supply parameter: outside: 5V DC 2Abuilt-in: 110-265V AC  48VDC5. Environmental temperature:<60,Relative humidity: 5%-90%8. TP cable: Cat5 UTP cable9. Transfer fiber: multi-mode: 50/125, 62.5/125 or 100/140μmsingle mode:: 8.3/125, 8.7/125, 9/125 or 10/125μm