BATTE Standard S20 melt pump control system adopts PLC mode and advanced human-machine interface, which can wholly control the pressure, temperature, flow, rotation speed, make the free change between automatic and manual control function. It can significantly reduce the pressure pulsation of the extruder caused by relative parameters, thus causes to stabilize the outlet pressure, and make the full use of the merits of melt pump in metering extrusion. It is configured with full set of Siemens PLC, control unit for pressure, temperature and flow, vector inverter, outlet and inlet pressure sensor, 5.7 inch touch-screen.
S20 Control System Consists of the Following Mounting: 1.2 closed-loop pressure control; 2. Top and bottom limitation pressure alarm; 3.3 independent temperature control zone/ comparator; 4. Flow control5. Automatic start-up and shut-down; 6. Touch screen human-machine interface; 7. Continuous monitoring of process value
| Environmental Conditions: Transportation and Storage |
between -40° C and 70° C |
| Ambient Temperature Range |
between 0° C and 55° C Horizontal Installation |
| Humidity Range |
The relative humidity of air is £ 95%, without icing or condensation. |
| Altitude |
Less than1000M |
| Shock and Vibration |
Offset: 0.075mm(10^58Hz) |
| Accelerated Speed:9.8m/s2(>58^.500Hz ) |
| Atmospheric Contamination |
It is not allowed to install the controller in the presence of atmospheric pollution,such as dust, corrosive gas environment. |
| Electromagnetic Radiation |
Never install the controller in the places close to the electromagnetic radiation source. |
| Water |
Please leave the controller far from where it is exposed to water. For instance, do not install the controller under the pipe, beacuse there might be condensation in the pipe surface. Furthermore, it is not allowed to install the controller where there is excessive humidity and there might be condenstion. |
| |
|
| Technical Parameter |
| Temperature Sensor |
K type Thermoucouple 0-400°C Accuracy 0.2°C |
| Pressure Sensor |
0-35Mpa Precision 1/3000 |
| Main Controller Requirement |
Being connected to our star-up, stop and emergency stop signals |
| Being connected to our speed output signal 0-10VDC |
| Heating Component |
Resistor type heating components are adopted, and the model changes according to the melt pump model. |
0 likes
China [CN] 
Click enlarge Image