Solar Shed Light Outdoor Garden Lights

if not all can enter the lamp plate and then rise a little, until the three light plate positioning pin all into the hook, then the switch down In the inverted (down) position, so that the lamp positioning pin into the bottom of the hook, while seeing the lamp is not falling or hoisting machine on the rope has been loose, it really hung the lamp on the hook, can be intermittent Ground down the lamp, until the lamp plate positioning pin hanging on the hook, rope loose so far. If you want to stop the lamp tray, you can drop the lamp panel to the lamp tray, Hook the following, you can use the way to rise slowly so that the lamp plate slowly rise until the lamp plate hanging on the hook so far. When the lamp is stable, the power plug will be inserted into the power plug on the power outlet, the door will be closed to tighten the inside of the hexagonal gong wire, close the control cabinet air switch, high pole lighting system power, adjust the switch time , The system can work properly. 5, the rise of the lamp panel limit: When you see the main wire rope on the rope marked the red mark near the edge of the wire rope hole, you can not rise the lamp, and must open the switch in the inverted (down) position, drop the lamp, Will be broken wire rope, there will be security incidents.

The entire lamp panel during the lifting process, the pole around the diameter of 4 meters does not allow someone! The The The The Every year at least two lifting system maintenance and inspection, including the main rope, vice rope and the card to see whether the broken rope, whether the loos loose or damaged, the number of oil reducer, the transmission part is intact , Whether the motor is working properly. The following are the same as the "Do not pay attention! The The following are the same as the "In order to high pole lights and the safety of people and property should be long-term listening to the weather forecast and pay attention to changes in the weather, in the storms and earthquakes, the high pole lights should be cut off the power, put the lamp down at the bottom of the pole to prevent just in case. The following are the same as the "Three: latitude and longitude microcomputer controller adjustmentAccording to the latitude control of the intelligent microcomputer timer and ordinary computer timer is different: the general computer timing switch is based on standard time for timing control, and intelligent microcomputer timer is based on changes in the four seasons of light;