Solar Lighting Manufacturers, and its vitality will be strong and lasting. In summary, the solar lighting products in the years after the wandering period, the technical improvement, the cost of the decline will eventually usher in a high-speed development period, and high-speed development will lead to further improve the technology and further reduce the cost , Such a virtuous circle, solar energy products will change the past "applauded" situation, usher in a new glory. Here, we would like to work with governments at all levels
His business together, give full play to their strengths, to create a new era of clean and make their own contribution! The life of solar lamps is much higher than that of ordinary electric lamps, such as the main components of solar lamps - the life of solar modules is more than 20 years; the life of electrodeless lamps is 60,000 hours, the average life of low pressure sodium lamps is 18,000 hours; Low-pressure high efficiency three primary colors energy-saving lamps average life of 6000 hours; super bright LED average life of 150,000 hours. Chengdu City, the new special lighting factory September 12, 2006 high pole lighting operation and precautions 1: high pole lighting operation must be carried out by two or more people, the control cabinet by a person operation, the rest of the staff attention to watch the lift position. 2: high pole lighting movements 1, open the power distribution control cabinet, the air switch separately, cut off the total power. 2, the poles check the door open, unplug the power plug, 3, the lamp down operation: the control cabinet up and down the switch in tune (liters) position, then, the lamp began to rise smoothly, when listening To the "da" a lock card positioning sound or see the lamp tray positioning pin out of the hook and lock the card to lock the hook, then down the switch in the inverted (down) position, the lamp began to decline, when the lights The disk down to about 2 meters from the ground when the stop down (down limit is 1.5 meters high from the ground), the inverted switch switch in the stop position, then you can carry out any operation on the lamp, such as lamps, electrical , Light source adjustment, maintenance. 4, the rising operation of the lamp: the control cabinet down and down the switch in the Shun (liters) position, when the lamp plate began to rise smoothly, when you see the lamp rose to the bottom of the vertical positioning pin (about 5 minutes ), The switch will be intermittent switch off the state (that is, a stop, to reduce the rising speed), when the rise into the hook, you can hear the "da" a light plate positioning pin into the hook sound , Then can be seen along the poles a week to see whether the three lampholders pin into the hook,
http://www.cn-solargardenlights.com/commercial-outdoor-lighting-manufacturers