HDPE temporary floor mats / construction road mats
What is our HDPE plastic HDPE construction floor road mats ?
Huao rugged ground protection mats make the going easy when you need to move heavy vehicles and equipment or high volumes of pedestrian traffic over soft or muddy ground.
These temporary road panels are capable of taking loads of up to a maximum of 120 tons and withstanding extremes of heat and cold. They are made from high density polythene so they easy to move and install by two men without the need for heavy lifting equipment.
HDPE Profile
HDPE is the abbreviation of High Density Polyethylene and it is an excellent engineering plastic.
HDPE was known by people for a step by step because it has many unique and useful properties. The density of HDPE is 0.94-0.98g/cm3. HDPE have many properties, such as high-wear-resistance,good-chemical resistance, low-temperature resistance, self-lubrication and high-impact resistance, soft and ductile, non-toxic tasteless and safety and healthy.
HDPE is widely used in industry, include the rope, woven bag, fishing nets, water pipes, non load bearing member, bollte.
The advantage of HDPE
---High Wear-Resistance.
---Anti-Weather & Long Service time.
---Self-lubrication, It has very low friction coefficient.
---Excellent chemical & corrosion resistant.
---Superior impact resistant, Noise- absorption, Vibration-absorption
---Temperature range: -100C ~ +80C.
---Tensile Strength is high.
---Non-Toxic and Tasteless.
---UV-resistance.
---Relatively low in water absorption.
---Good performance in resisting environment stress crack, 200 times of ordinary PE.
---Not easy adhesion.
---Light weight and easier to handle, easy Reprocessed.
---Low Cost, Low energy consumption.
---Does not rot, split or crack; 100% recyclable.
---Great liner material for industrial material handling
Property of HDPE
Propertise |
Unit |
Result |
Density |
g/cm3 |
0.965 |
Max Continuous Operating Temp: |
℃ |
80 |
Max Short Term Operating Temp(3~4hours): |
℃ |
130 |
Tensile Strength at Yield: |
Mpa |
28-40 |
Tensile Strain at Yield |
% |
21 |
Tensile Strength |
MPa |
25-45 |
Elongation at Break |
% |
200-900 |
Hardness Rockwell: |
- |
M55,D60-D70 |
Dielectric Strength: |
KV/mm |
45-55 |
Surface Resistivity: |
Ohms |
>1014 |
Impact Resistance Charpy Notched: |
KJ/m2 |
>100 |