Conventional fire alarm control panel Fire Fighting Panel HS-CK1004 with 4 zones.
General Conventional Fire Alarm Control Panel with four Zones
|
||
|
Conventional Fire Alarm Control Panel with four Zones
1 pc/carton box;carton M:43*17*51cm
OEM & ODM or Any one of our existing product designs can also be modified to meet your specific requirements.
BEFORE INSTALLING
NOTICE: This manual should be left with the owner/user of this equipment.
GENERAL DESCRIPTION
The conventional manual call point designed for conventional fire alarm system for
reporting fire or emergency condition by its PUSH IN/PULL DOWN handle latches.
One 470 ohm resistor is used on the PCB board between Zone+ and Zone- when
the switch inside is closed. So the conventional manual call point is only used with
conventional fire alarm control panel, it is forbidden to be used to other system.
OPERATION
The manual call points provide a textured finger-hold area that includes Braille text.
In addition to PUSH IN and PULL DOWN text, there are arrows indicating how to
operate the station, provided for non-English-speaking people.
Pushing in and then pulling down on the handle activates the normally open alarm switch.
Once latched in the down position,the word “ACTIVATED” appears at the top in bright yellow,
with a portion of the handle protruding at the bottom as a visible flag.Resetting the station is
simple: insert the key, twist one quarter-turn, then open the station’s front cover, causing the
spring-loaded operation handle to return to its original position. The alarm switch can then be
reset to its normal (non-alarm) position manually (by hand) or by closing the station’s front cover,
which automatically resets the switch.
Loop Design and Wiring
Conventional Fire Alarm Control Panel with four Zones
The fire alarm control panel Zone wire can be connected to terminal loop (+), loop (-) unpolarized wire.
If the manual call point is in the end of the zone wire, a 5.6K resistance should be connected to
terminal loop (+), loop (-).
INSTALLATION
NOTE: All wiring must conform to applicable local codes, ordinances, and regulations.
Mounting Indoor Wall
1. Attach mounting base to wall at 1.5 meter’s high.
2. Connect field wiring to terminals
3. To attach product to mounting base.
4. Secure product by tightening the one mounting screws in the front of the product housing.
Advantage we have
A.experienced manufacturers;
B.alibaba golden supplier ,factory recognized by ccc;
C.7/24service for you ,all the question will be dealed within 24hours;
D.Benefit you get
Stable quality---coming from good material and technic.
Lower price---not cheapest but the lowest at the same quality.
Good service --satisfactory service before and after sale.
Delivery time ----30days for mass production.