In order to extend the life of the cutting disc when using the
free sample cutting disc, it is sometimes necessary to carry out the corresponding maintenance. So what are these conservation measures? Today, Aurora abrasives come to give you a total of all.
1. When the cutting disc is no longer sharp and the cutting surface is rough, it must be repaired in time. Grinding does not change the original angle and destroys the dynamic balance.
2. The inner diameter correction of the cutting disc and the processing of the positioning hole must be carried out by the factory. If the processing is poor, it will affect the product use effect, and may be dangerous. The hole expansion principle should not exceed the original hole diameter of 20mm in order to avoid affecting the stress balance.
3. If the cutting disc is not used immediately, it should be laid flat or suspended by the inner hole. The other pieces or feet should not be stacked on the flat saw blade, and attention should be paid to moisture and rust.
To achieve the above points, the cutting disc can be maintained to a certain extent, hoping to help everyone better use and maintain the cutting disc.